What Factors Can Influence the Processing Capacity of Raymond Mill

Generally, there are many reasons to influence the processing capacity of Raymond mill. It mainly has five aspects. Here, Hongxing will introduce those factors and take some according solutions.

1. The hardness of material.

The harder the material is, the more difficult to be broken, which will cause more serious abrasion to Raymond mill. The capacity of making sand is small if the speed of making sand is slow, which requires that users should choose the materials of moderate hardness.

2. The composition of material.

It has a large influence on sand making that the material contains too much fine powder. Because the powder easily adhere to affect conveying. Therefore, the material with more fines should be sieved in advance. The fine powder should be filtered from the material as much as possible to avoid affecting the normal operation of the sand making equipment.

3. The fineness of materials after sand making

The fineness requirement is high, that is, the capacity of sand making is smaller if the material required by sand making is finer. It is determined according to the detailed demand of beneficiation plan. It there is no special requirement, the fineness of material can be designed to be medium fine.

4. The viscosity of material

It is easier to adhere if the viscosity of material is bigger. The material of large viscosity will adhere in the inner wall of sand making chamber in Raymond mill. If it is not cleaned in time, it will seriously influence the working efficiency, even affect the normal working. Therefore, users must not choose the material with large viscosity.

5. The humidity of material

When the moisture contained in the material is large, the material is easily adhered in Raymond Mill, and it is also easy to be blocked in the process of discharging material, resulting in a decrease in sand making capacity. In order to solve this problem, firstly, the humidity of material should be controlled strictly when choosing materials. If the humidity of chosen material is too large, users can utilize the sun or air to reduce the percentage of water in the material.

To produce national sand, the first thing is to choose good material. How much is the feeding size? How large is the required output? Both of them can be flexibly chosen according to the investment cost and actual site. Of course, the configuration of Raymond Mill is also based on this condition.